3605問題集、Avaya実際の試験問題

質問 1

Avaya recommends using RSMLT edge in place of VRRP with Backup Master,
when available what are two valid reasons for using RSMLT edge? (Choose two)

正解:

解説: (PassTest メンバーにのみ表示されます)

質問 2

The trace level 9 3 command accomplish?

A. It captures RCC IP events at verbose level.

B. It captures packets copied to the CPU at a verbose level.

C. It shows CPU utilization.

D. It captures BGP events at a terse level.

正解: B

質問 3

A customer needs to install a new Ethernet Routing Switch (ERS) 2550T on the 172.16.5.0/24
network, but does not have a
console
cable available.
Which statement is correct?

A. To communicate with an ERS 2550T the IP address must first be set though the console interface.

B. The customer
can set the switch to use the temporary
address of
192.168.192.168 by pressing the User Interface button on the front of the ERS 2550T

C. The customer can connect to the network management Ethernet port which is pre-configured to use the 192 168 1 1/24 IP address

D. The switch will first attempt to use BootP to acquire an IP address, and if that fails it will assign IP address 192.160.1.1/24 to the switch IP.

正解: C

質問 4

By default the ERS 8000 is configured for warm standby. After installation of a new ERS solution with dual CPUs, which three actions need to be Perform on the ERS configuration to ensure high availability mode is enabled and will function correctly? (Choose three)

A. Save the boot.cfg conflg file and reset the switch to activate the changes.

B. Set the high availability CPU boot flag to true.

C. Set the save to standby CPU boot flag to true.

D. Set the warm standby CPU hoot flag to false.

E. Install the high availability license file.

正解: B

解説: (PassTest メンバーにのみ表示されます)

質問 5

Which two functions describe VPFM? (Choose two.)

A. It is a device configuration tool.

B. It is another term for the SNM credential.

C. It can correlate faults, traps, and provide notification.

D. It is a network health at a glance tool.

正解: C,D

質問 6

Which steps are initial steps required to configure the Ethernet Routing Switch (ERS) 8600 in a clustered basic core configuration? (Choose three.)

A. configure SMLT

B. create the IST

C. create VLANs

D. enables OSPF

正解: C

解説: (PassTest メンバーにのみ表示されます)

質問 7

Ethernet Routing Switch (ERS) 5500 portfolio shares a number of common hardware features. Which feature is unique to the ERS 5530 and is not available on the other ERS 5500 switches?

A. Network management Ethernet port

B. Universal Serial Bus (USB) port

C. Console serial port

D. User Interface push button

正解: B

質問 8

A customer has implemented
an ERS 8000 solution
and deployed the configuration and Orchestration Manager (COM). Which tool from within COM is used to set up and manage spanning tree groups?

A. VLAN Manager

B. Security Manager

C. VSN Manager

D. Global Manager

正解: A

質問 9

The ERS 8000 backplane hosts an EEPROM for storage of up to 4096 MAC addresses. The MAC addresses are automatically used up as they are assigned to which three of the following?

A. Switch physical ports

B. Multi-Link Trunking groups.

C. IPX interfaces.

D. Multi-Link Trunking ports.

E. VLANs.

正解: A

解説: (PassTest メンバーにのみ表示されます)

質問 10

RSMLT Edge is enabled globally on two ERS 8800 switches. After recovering from a power outage some clients cannot communicate. A technician determined that only one of the core switches has recovered. What should the technician check to ensure that this loss of communication does not occur in the event of a future power outage or other failure?

A. Turn off the Hold Up timer on both core switches.

B. Set the VLAN to copy RSMLT info from a similarly configured VLAN.

C. Re-enable RSMLT Edge on each of the VLANs on both switches.

D. Increase the Hold Up Timer to 9999 per VLAN for RSMLT Edge support.

正解: D

質問 11

IPFIX protocol used for the export of flow information from traffic observed on a
switch. Which three statements are true for the functioning of the IPIX protocol?
(Choose three)

A. ACls can be used to configure IPFIX on a per port/slot basis.

B. The IPIX exporter handles sending packets to the collectors.

C. IPFIX requires dual CPUs installed for the ERS 8000.

D. The IPMX information cannot be exported to a 3rd-party application.

正解: A,B,C

質問 12

Virtual forwarding eliminates the need for multiple physical routers. What is the difference in the Virtual Routing forwarding (VRF)-Lite configuration from Ethernet Routing switches (ERS) 8600/8800 to ERSS300?

A. On ERS 8600/8800, VRF-Lite virtualizes the control and data plane as well as the routing tables.

B. 8300 supports 250 virtual routers; ERS 8600/8800 supports 256.

C. ERS 8600/8800 supports inter-VRF routing policies.

D. ERS 8300 supports Inter-VRF routing policies

正解: C

質問 13

The technician is setting up an Ethernet Routing
Switch (ERS) 8300 switch for QoS. It has been determined that unimportant traffic will be marked on the edge of the network with a default IEEE 802.Ip setting off 0. Since the ERS 8300 is in the core, the traffic must be identified with the proper class of service. The technician has used JDM to look at the TrafficClass Map with the shown in the exhibit.

What can be determined from the ERS 8300 parameters?

A. The ERS 8300 mapping is normal and should be left as is

B. The ERS 8300 mapping has been altered since the IEEE 802.lp settings do not map directly to the same Traffic Class.

C. The ERS 8300 as a core device
will not
use the IEEE 802.1 p to Traffic Class Map for this application.

D. The ERS 8300 mapping will push the IEEE 802. ip setting off 0 above the network control traffic.

正解: B

質問 14

Consider the following port conditions on an Ethernet Routing Switch (ERS)
8648GTRS 10/100/1000 Ethernet I/O module: Left LED - green Right LED -
flashing What is the status of the port?

A. The link speed is 100 Mbp, and the port is disabled.

B. The link speed is 100 Mbps, and the port is passing traffic.

C. The link speed is 1000 Mbps, and the port is disabled.

D. The link speed is 1000 Mbps, and the port is passing traffic.

正解: D

質問 15

The attempt
to manage
an Ethernet Routing
Switch (ERS)
8600 using a VRRP address
was unsuccessful. What is causing this problem?

A. A real IP address is required for management access not a VRRP address.

B. The incorrect MAC offset is configured for the VRRP address.

C. The fie virtual router identifier is 0.

D. The datacenter interface is set as a critical IP interface.

正解: A

Avaya Ethernet Routing Switch Implementation and Maintenance - 3605 模擬練習