6002問題集、Avaya実際の試験問題

質問 1

A customer is planning to upgrade from CM 5X to CM 6.0 an existing 8510 server.
What is the total minimum memory requirement for this upgrade?

A. 16 GB RAM

B. 12 GB RAM

C. 4 GB RAM

D. 8 GB RAM

正解: D

質問 2

In which two modes is communication manager Release 6.0 deployed? (Choose two)

A. System management

B. Signaling server

C. Feature server

D. Evolution server

正解: C,D

質問 3

Which two components are part of the Avaya Aura CM_Simplex template? (Choose two)

A. Session manager 6.0

B. Utility services

C. Avaya Enablement Services (AES)

D. CM 6.0

正解: B,D

質問 4

Which three procedures are used to determine whether a gateway with a survivable remote server has lost its H.248 link (connection) to the main (Primary) servers? (Choose three)

A. Execute the Communication Manager command display alarms, to see whether the No
Service Timeout Timer (NSTT) has expired

B. Execute the SAT command status media-gateways, to determine which media gateways are not registered to the main server

C. Execute the SAT command List media-gateway from the remote survivable server, to determine whether the media gateway is registered with a survivable server

D. Execute the command status H.248 line from the remote gateway, to determine whether the link to the main server is active

E. Execute the Communication Manager command display alarms, to see whether the Link
Loss Delay timer has expired

正解: B,C,E

質問 5

Which gateway command resets the Gateway back to factory default?

A. Nvram init

B. Reset

C. Restart

D. Softboot

正解: A

質問 6

Which statement describes the action to assure the CM_SurvRemoteEmbeded template was installed correctly?

A. From a browser logged into the system Management console verify cm, bsm, and utility_server and application status is running

B. From a browser logged into communication Manager, Select administration > server
(Maintenance)> server>Process Status. Click on view.

C. From a browser, using the communication manager IP address, successfully log into the communication manager system management.

D. When monitoring the template installation workflow status, verify the message. "Wizard completed successfully" displays.

正解: A

質問 7

A customer has a communication Manager R6.0 system with IP phones and some older
TDM phone, and says there is no dial tone for all of the IP phones. All of the hardware has been verified to be working properly.
Which two steps can be taken to identify the cause of problem? (Choose two)]

A. Set a static IP address on a laptop and see if the TN2602 Media Resource circuit pack can be pinged.

B. Set a static IP address on a laptop and see if the server can be pined

C. Verify that the TN2602 Media resources circuit pack has the correct IP settings.

D. Verify that the processor Ethernet mode is enabled in the Server.

正解: A,C

Avaya 6002.1 Avaya Aura(TM) Communication Manager and CM Messaging (R6.0) Implementation - 6002 模擬練習