API-SIEE問題集、API実際の試験問題

質問 1

NEMA rated motor controllers require a minimum range of conductor sizes for a specific size controller.
Which of the following conductor sizes is appropriate for a Size 2 controller?

A. 2/0 AWG -250MCM at 60°C rated cable and 2/0 AWG -350MCM at 75°C rated cable

B. 2-2/0 AWG at 60°C rated cable and 2-4/0 AWG at 75°C rated cable

C. 10-4 AWG at 60°C rated cable and 10-6 AWG at 75°C rated cable

D. 10-2/0 AWG at 60°C rated cable and 10-4/0 AWG at 75°C rated cable

正解: C

解説: (PassTest メンバーにのみ表示されます)

質問 2

Which switchgear-related item is explicitly identified in the guide table of contents as an inspection topic?

A. Turbine nozzle alignment

B. Firewater pump casing hardness

C. Cable tray color coding

D. Metering

正解: D

質問 3

Who is responsible for verifying that Non-conformance report NCR disposition has been properly implemented?

A. Vendor's Quality Manager

B. Source Inspector

C. Manufacturing Engineer

D. Inspection Coordinator

正解: B

解説: (PassTest メンバーにのみ表示されます)

質問 4

What requirement shall be included in a lockout/tagout procedure?

A. A power testing requirement where a direct exposure situation can be detected

B. A voltage and current testing for direct exposure situations

C. A voltage testing requirement where there might be direct exposure to electrical hazards

D. An arc flash requirement where a high level of exposure is foreseen

正解: C

質問 5

Which statement BEST describes the role of source inspection during manufacturing and fabrication?

A. It transfers all responsibility for product quality to the inspector

B. It verifies whether the supplier's quality system is functioning properly

C. It replaces the supplier's quality system

D. It is limited to post-shipment activities

正解: B

質問 6

The evaluation of a component for compliance with product specification and data sheet is known as:

A. documentation.

B. validation.

C. standardization.

D. inspection.

正解: D

解説: (PassTest メンバーにのみ表示されます)

質問 7

What is the purpose of an insulation resistance reading?

A. To determine if the conductors are properly terminated

B. To determine the resistance of the conductors

C. To evaluate the condition of the insulation between conductors and ground

D. To evaluate the insulation and condition of the grounding

正解: C

解説: (PassTest メンバーにのみ表示されます)

質問 8

According to ANSI/NETA/ATS, when performing a dielectric withstand test on each bus section, the test voltage shall be applied for how long?

A. One hour

B. One second

C. One day

D. One minute

正解: D

解説: (PassTest メンバーにのみ表示されます)

質問 9

What electronic instrument is used for measuring electrical potential difference between two points in an electric circuit?

A. Potentiometer

B. Amp meter

C. Voltmeter

D. Wheatstone bridge

正解: C

解説: (PassTest メンバーにのみ表示されます)

API Source Inspector Electrical Equipment - API-SIEE 模擬練習