C-TSCM42-65問題集、SAP実際の試験問題

質問 1

Which function is supported by production orders?

A. Automatic printing of order documents at order creation

B. Automatic selection of a work center at order release

C. Automatic creation of transfer orders at order release

D. Automatic reading of PP master data at order release

正解: C

質問 2

Where can you define the default storage location for the material component of a production order? (Choose three)

A. Routing

B. Production version (product)

C. Material master (component)

D. Production supply area of a work center

E. BOM header (product)

正解: B,C,D

質問 3

The final assembly of a finished product should only be triggered when a customer order arrives.
Which planning strategy for the finished product do you use?

A. Planning with final assembly (strategy 40)

B. Planning without final assembly (strategy 50)

C. Planning with make-to-stock (strategy 10)

D. Planning at the assembly level (strategy 70)

正解: D

質問 4

Which of the following elements can be used in a process order? (Choose three)

A. Suboperations

B. Process instructions

C. Parallel sequences

D. Phases

E. Relationships

正解: B,D,E

質問 5

Which of the following statements about consumption are correct? (Choose two)

A. Consumption parameters (consumption mode and consumption interval) can be set in the material master or in the MRP group.

B. Consumption is restructured with the planning run.

C. Consumption takes place on the material level between the planned independent requirements and the planned orders.

D. Consumption can take place between order reservations and planned independent requirements, depending on the strategy.

正解: A,D

質問 6

Which of the following functions are available in SAP ECC when using capacity leveling? (Choose three)

A. Lot size optimization

B. Finite capacity scheduling

C. Batch size optimization

D. Setup time reduction

E. Midpoint scheduling

正解: B,D,E

質問 7

Which functions can be triggered before releasing a production order? (Choose three)

A. Selection of a routing

B. Selection of a BOM

C. Confirmation

D. Stock determination

E. Scheduling

正解: A,B,E

質問 8

You want to produce a finished product only when it is requested by a customer order in make-to-order production. However, all assemblies need to be procured beforehand.
How can you fulfill these requirements in SAP ECC? (Choose two)

A. Use strategy 30 (production by lots) for the finished product and strategy 70 (planning at the assembly level) for all assemblies in the bill of material.

B. Use strategy 20 (make-to-order production) for the finished product and strategy 70 (planning at the assembly level) for all assemblies in the bill of material.

C. Use strategy 40 (planning with final assembly) for the finished product and strategy 70 (planning at the assembly level) for all assemblies in the bill of material.

D. Use strategy 50 (planning without final assembly) for the finished product and no strategy for all assemblies in the bill of material.

正解: B,D

SAP Certified Application Associate - Production - Planning & Manufacturing with SAP ERP 6.0 EHP5 - C-TSCM42-65 模擬練習