SAP Certified Application Associate - Planning and GATP in SAP SCM APO 7.0 EHP1 - C-TSCM44-65 模擬練習

A. It keeps data in the internal BW and liveCache consistent.

B. It keeps data for different key figures consistent at all levels.

C. It stores data consistently in aggregates and at the lowest level.

D. It keeps data for different characteristic value combinations consistent.

E. It keeps the data for one key figure consistent at all levels.

A. ATP rules

B. Pegging status of demands

C. Sequence from Customizing

D. Availability of location products

E. Sequence from the CTM profile

A. Transfer ECC planning strategy 50 (planning without final assembly) and the individual/collective requirements indicator 2 (collective requirements only) to the APO finished product via CIF.

B. Transfer ECC planning strategy 52 (planning without final assembly without make-toorder) to the APO finished product via CIF.

C. Copy APO requirements strategy 30 (planning without final assembly), change the settings for the PIR segment to "without individual requirements" and assign the strategy to the finished product.

D. Transfer ECC planning strategy 40 (planning with final assembly) to the APO finished product via CIF and define a conversion rule with a requirements check in APO that is also assigned to the finished product.

A. In the product master, maintain the safety stock method BS (Beta service level and reorder point method).

B. Define the DP key figures from which the system can derive forecast accuracy and replenishment lead time accuracy or enter the accuracy in the product master.

C. Configure the SSP planning run and schedule after the SNP planning run.

D. Create a safety stock planning (SSP) profile and select lead time calculation by critical or average duration of possible paths.

E. In the product master, maintain the safety stock method AS (Alpha service level and reorder point method).

A. In the check instruction

B. In the check control

C. In the scope of check

D. In the check mode

A. It summarizes all requirements within a predefined bucket and does not confirm individual requirements.

B. It schedules against bucket capacity instead of confirming against time-continuous capacity.

C. It allows confirmation against SNP capacity key figures.

D. It uses lot size rounding profiles to calculate bucket quantities instead of scheduling lot-for-lot.

A. It is the only SNP planning method that can plan warehouse resources finitely.

B. It finds only the first feasible solution.

C. It uses a constraint propagation algorithm.

D. It is controlled by costs that can be transferred from ECC.

A. A number of predefined planning algorithms are offered for the PP and DS application, even though these are hard coded and cannot be modified or increased.

B. Heuristics are predefined planning algorithms for MRP planning only. The main advantage compared to MRP in ECC is the possibility to influence system behavior.

C. The heuristic SAP_PP_002 (planning of standard lots) plans in an almost identical way to the ECC MRP.

D. The heuristic SAP_PP_007 (reorder point planning) allows you to plan the selected products on a demand-driven basis, even though the materials are defined as consumption-based.

E. The heuristic SAP_PP_019 (fix pegging relationships) belongs to the category of service heuristics and enables you to stabilize the planning results.