Huawei HCIP-Carrier IP V2.0 - H31-124_v2.0 模擬練習

A. To allocate different LSP for each VPN.

B. To allocate unique RD for each VPN.

C. To allocate unique RT for each VPN.

D. To maintain separate VRF lor different VPN.

E. To use different routing protocols In the backbone network for afferent VPN.

A. The priority of the DMZ is 50

B. The priority of the Trust zone is 80

C. The priority of the Local zone is 100

D. The priority of the Untrust zone is 15

A. When the priority is the same, the router with higher IP address will be elected as the DIS.

B. The IS-IS router with the highest priority in the whole broadcast network will be elected as the DIS.

C. When a DIS fails, the backup DIS will take over.

D. DIS election is configured manually.

A. CAR uses token bucket mechanism to measure traffic and allocate bandwidth.

B. CAR can be used for incoming interface and outgoing interface.

C. CAR and queue scheduling cannot be used at the same time because of confliction.

D. CAR can be used to limit the rate of the specific type of traffic.

A. Hellolnterval can be modified by administraor.The smaller the value, the faster (he topology change discovery.

B. Hellolnterval is 10 seconds for NBMA and broadcast network by default.

C. The range of Hellolnterval is from 0 to 65535.

D. Hellolnterval is 30 seconds for P2P and P2MP network by default.

A. Configure the same cost to generate two equal-cost routes.

B. Configure different costs to generate two routes with different costs.

C. Configure static routes or an IGP to implement IP connectivity between nodes.

D. Configure a dynamic routing protocol on the entire network to Implement IP connectivity between nodes.