NS0-180問題集、Network Appliance実際の試験問題

質問 1

A remote administrator is connecting to a cluster from a different remote network.
According to NetApp best practices, which type of LIF routing is required to accomplish this task?

A. data LIF

B. cluster management LIF

C. cluster LIF

D. intercluster LIF

正解: A

解説: (PassTest メンバーにのみ表示されます)

質問 2

You are asked to install a 6-node cluster of FAS8080 controllers. The installation has been completed and Config Advisor shows no warnings or errors. The customer can ping and access the controller.
Which statement is true in this scenario?

A. This installation has not been completed successfully until the customer and NetApp Support have received a minimum of three AutoSupport messages.

B. This installation has not been completed successfully until you have confirmed that SSH is enabled.

C. This installation has been completed successfully, because Config Advisor would identify the missing configuration.

D. This installation has been completed successfully only if you have confirmed that the configuration is correct.

正解: D

解説: (PassTest メンバーにのみ表示されます)

質問 3

Which three types of interface groups are supported on NetApp storage systems? (Choose three.)

A. single mode

B. dynamic multimode

C. IPspaces

D. static multimode

E. HA interconnect

正解: A,B,D

解説: (PassTest メンバーにのみ表示されます)

質問 4

You want to create a data volume on aggr0 and you receive a message with the following warning:
''Warning: You are about to create a volume on a root aggregate. This may cause severe performance or stability problems and therefore is not recommended. Do you want to proceed?''
What is the reason for this severe performance or stability problem?

A. Controller failover and storage failover are separate processes that must occur at different times, otherwise problems will arise.

B. The performance load generated by the vol0 cannot be shared with any other volume on aggr0, requiring a dedicated aggregate for it.

C. Controller failover and storage failover are separate processes that must occur in parallel, otherwise problems will arise.

D. The performance load generated by the data volume can be very strong, so it should not be shared with vol0 on aggr0, requiring a separate aggregate for it.

正解: D

解説: (PassTest メンバーにのみ表示されます)

質問 5

You are assigned to install five DS2246 with twenty-four 400 GB SSDs per shelf to a single node system.
According the NetApp, which statement is correct?

A. You can put all shelves in one stack.

B. You need at least three stacks.

C. You cannot install five SSD shelves to one System.

D. You need at least two stacks.

正解: A

解説: (PassTest メンバーにのみ表示されます)

質問 6

You are preparing to install a new 4-node cluster for your customer. They want to use NetApp CN1610 cluster switches that they previously purchased.
Which software must be downloaded to ensure that you are well prepared for this installation?

A. You must download CN1610 firmware and RCF files compatible with the clustered Data ONTAP version that your customer wants to use.

B. You must download ATTO Fibre Bridge firmware.

C. You must download the System Setup tool.

D. You must download the Cisco configuration files compatible with the clustered Data ONTAP version that your customer wants to use.

正解: A

解説: (PassTest メンバーにのみ表示されます)

質問 7

After proper cabling the NetApp CN1610 cluster switches, you notice that joining the second node to a cluster fails because the node is not able to communicate with the other node.
What would be the reason for this malfunction?

A. The cluster switches must be Cisco switches for two or more nodes in a cluster.

B. CN1610 is unsupported in newer clustered Data ONTAP versions.

C. The NTP server is not set.

D. The FASTPATH version is not supported.

正解: D

解説: (PassTest メンバーにのみ表示されます)

Network Appliance NetApp Certified Storage Installation Engineer, Clustered Data ONTAP - NS0-180 模擬練習