NSE6_FWF-6.4問題集、Fortinet実際の試験問題

質問 1

Refer to the exhibit.

If the signal is set to -68 dB on the FortiPlanner site survey reading, which statement is correct regarding the coverage area?

A. Areas with the signal strength weaker than -68 dB are highlighted in orangeand red to indicate that no signal was propagated by the APS.

B. Areas with the signal strength weaker than -68 dB are shown with blackbackground.

C. Areas with the signal strength equal to -68 dB are zoomed in to providebetter visibility.

D. Areas with the signal strength equal or stronger than -68 dB are highlighted in green circles.

正解: D

解説: (PassTest メンバーにのみ表示されます)

質問 2

As a network administrator, you are responsible for managing an enterprise secure wireless LAN. The controller is based in the United States, and you have been asked to deploy a number of managed APs in a remote office in Germany.
What is the correct way to ensure that the RF channels and transmission power limits are appropriately configured for the remote APs?

A. Configure the controller for the correct country code for Germany

B. Configure the APs individually by overriding the settings in Managed FortiAPs

C. Create a new FortiAP profile and change the county code settings on the profile

D. Clone a suitable FortiAP profile and change the county code settings on the profile

正解: C

解説: (PassTest メンバーにのみ表示されます)

質問 3

Which two statements about distributed automatic radio resource provisioning (DARRP) are correct? (Choose two.)

A. DARRP performs measurements of the number of BSSIDs and their signal strength (RSSI). The controller then uses this information to select the optimum channel for the AP.

B. DARRP measurements can be scheduled to occur at specific times.

C. DARRP requires that wireless intrusion detection (WIDS) be enabled to detect neighboring devices.

D. DARRP performs continuous spectrum analysis to detect sources of interference. It uses this information to allow the AP to select the optimum channel.

正解: A,B

解説: (PassTest メンバーにのみ表示されます)

質問 4

Which administrative access method must be enabled on a FortiGate interface to allow APs to connect and function?

A. HTTPS

B. FortiTelemetry

C. SSH

D. Security Fabric Connection

正解: D

Fortinet NSE 6 - Secure Wireless LAN 6.4 - NSE6_FWF-6.4 模擬練習