2026年においても、IBMが実施するIBM i Administration V1はIT業界で高く評価される公式認定試験のひとつです。PassTestではこのC9010-030試験に特化した練習問題68問を収録し、認定取得に向けた学習をサポートします。

IBM C9010-030 試験概要:

IBM C9010-030 試験シラバストピック:

IBM C9010-030 試験 Q&A まとめ

IBM i Administration V1 認定 C9010-030 試験問題：

問題 #1

An administrator has noticed that the number of security audit journal receivers on the system is getting unmanageable.
How can the administrator adjust the journal to still capture and retain the required journal entries but generate fewer receivers?

A. Create a new journal receiver setting the threshold to a higher value.
B. Change the current journal receiver to a higher threshold value.
C. Change the security journal to delete journal receivers.
D. Create a new security journal specifying the number of receivers to use.

問題 #2

A P0WER8 system with a single FSP is running firmware SV830_048. When the administrator goes to Fix Central, the latest firmware is SV830_068_050.
What is the effect of installing this software?

A. The upgrade is disruptive because the only PowerKVM upgrades are concurrent when using OPAL.
B. The upgrade would be disruptive as the 050 in the latest firmware is higher than the 048 currently running on the FSP.
C. Since both the installed and the new firmware are at SV830, the upgrade will be concurrent when done from the OS.
D. The upgrade is concurrent because the 068 and the 050 are not the same number.

問題 #3

An administrator needs to set up and configure a monitor for CPU usage under Management Central > Monitors.
Given the image below:

What is used to set up this monitor?

A. File
B. Message
C. System
D. Job

問題 #4

A subsystem description is configured as shown in the following screens;

Users are assigned to each job queue to run their batch work. The users assigned to the ACCOUNTING job queue are complaining that their batch jobs are occasionally not running. Other users do not experience this issue.
Why are ACCOUNTING users experiencing this problem?

A. The auxiliary storage pool group is not set to match the number of job queue entries in the subsystem.
B. The jobs in the ACCOUNTING queue are run at the lowest execution pnonty based on the sequence number field Jobs from CORP and ENGR are consuming all the processing capability allowed for the subsystem.
C. The run priority of the job does not match the sequence number of the job queue entry.
D. The subsystem starts jobs up to the maximum allowed for each job queue starting with the lowest sequence number (SEQ NBR column)

問題 #5

A Power Systems server with SAN attached disk has redundant fibre HBAs and two paths provisioned through the SAN fabric.
One fibre HBA has been replaced, but the redundant path shows a failed status.
What is the most likely cause of this problem?

A. The multipathing exit program (QIBM_QZSC_SANP2) has failed.
B. The multipathing daemon has failed.
C. The new adapter was not dynamically allocated to the partition.
D. The WWPN has changed.

解説：