[2022年05月21日] 完全版最新のNCM-MCI-5.15問題集で100%カバー率問題と解答があなたをリアル試験で合格させる
最新NCM-MCI-5.15試験問題集で有効最新の問題集
質問 10
An administrator is deploying several new application VMs to a Nutanix cluster. The application is very transactional with a 28/72 random, read/write ratio.
What should the administrator do?
- A. Add a minimum of four SSDs to each node to ensure all writes go to the SSDs.
- B. Add a minimum of four virtual disks to each VM, and aggregate them on guest OS level.
- C. Add one large virtual disk to each VM. and use it for all application data.
- D. Add one large SSD to each node and enable Flash Mode for the VMs.
正解: B
解説:
Explanation
Ref: https://next.nutanix.com/server-virtualization-27/iops-latency-issue-1168
質問 11
An administrator is implementing a VDI solution. The workload will be a series of persistent desktops in a dedicated storage container within a four-node cluster. Storage optimizations should be set on the dedicated storage container to give optimal performance including during a node failure event.
Which storage optimizations should the administrator set to meet the requirements?
- A. Compression only
- B. Deduplication and Erasure Coding
- C. Compression, Deduplication, and Erasure Coding
- D. Compression and Deduplication
正解: B
解説:
Explanation
Ref:
質問 12
An administrator wants to utilize Network Visualization to monitor the physical and logical network on the Nutanix cluster. The first-hop switch has LLDP enabled. The network switch information is still not being displayed.
What is causing this problem?
- A. br0 and br1 are not defined.
- B. The ISL between switches is not configured.
- C. SNMP is not configured properly.
- D. The cluster is using RDMA-enabled NICs.
正解: C
解説:
Explanation
ref:
https://portal.nutanix.com/page/documents/details?targetId=Web-Console-Guide-Prism-v55:wc-network-visualiz
質問 13
An administrator deploys Exchange on a Nutanix cluster. The administrator creates two containers with RF2 configuration:
* One container for Exchange
* One container for the other VMs
The Exchange VM is experiencing I/O performance issues.
Which changes to Storage Optimization should be used on the Exchange container to enhance I/O performance?
- A. Post process Deduplication only
- B. Inline compression and Deduplication
- C. Inline compression and EC-X
- D. No data reduction
正解: D
質問 14
An administrator has two clusters: Site A and Site B.
Async DR is configured between the clusters as follows:
* Site A is the Primary Site
* Site B is the Secondary inactive Site, no VMs running
* Site A is fully in Production
* Site B used as Backup/Disaster Recovery
The customer wants to perform a planned failover between the sites.
How should the administrator accomplish this?
- A. Click Activate on the Secondary site within the Data Protection Dashboard
- B. Choose Migrate on the Primary site within the Data Protection Dashboard
- C. Click Activate on the Secondary site and run deactive NCLI command on Primary site
- D. Choose Migrate on the Secondary site within the Data Protection Dashboard
正解: B
解説:
Explanation
Ref:
https://portal.nutanix.com/page/documents/details?targetId=Web-Console-Guide-Prism-v510:wc-protection-dom
質問 15
An administrator needs to expand a cluster based on AHV and running on Nutanix G5 hardware with a new Nutanix G7 system. The cluster is running AOS 5.10 but the operation fails when expanding the cluster. AOS is running on the new system. There are no issues discovering the node.
Why is the operation failing?
- A. Foundation software has not been updated on the cluster.
- B. G7 hardware cannot be added to a G5 cluster.
- C. AOS version running on G7 is older than the version on the cluster.
- D. EVC needs to be configured before cluster expansion
正解: C
解説:
Explanation
Ref: https://next.nutanix.com/installation-configuration-23/product-mixing-restrictions-37231
質問 16
An administrator receives an error indicating that the CVMs in the cluster are not syncing to any NTP servers.
An investigation of the issue finds:
* The NTP servers are configured in Prism
* The time on all CVMs is the same
* Both the CVMs and AHV hosts are configured for the UTC time zone
Which two steps can be taken to troubleshoot this issue? (Choose two.)
- A. Restart the chronos service on all CVMs.
- B. On a CVM. run the command a Hash ntpq -pn.
- C. Confirm that the NTP servers are reachable from the CVMs.
- D. Restart genesis on all CVMs.
正解: B,C
解説:
Explanation
Ref: https://portal.nutanix.com/page/documents/kbs/details?targetId=kA032000000bmjeCAA#Review_ntpq
質問 17
An administrator needs to forecast infrastructure requirements for a new program and its associated applications. Prior to the projected start of the new program, all existing applications will be decommissioned.
How should the administrator perform this task?
- A. Power down the workloads during a maintenance window and run the Capacity Runway.
- B. Add up the recovered workloads and manually remove from the Runway configuration.
- C. Check the Disregard Existing Workloads radio button in the Runway scenario.
- D. Check the Disregard Existing Nodes radio button in the Runway scenario.
正解: C
質問 18
An administrator is configuring an All Flash cluster to support the following workloads:
* Full clone virtual desktops
* Hadoop
* Write heavy databases
Which three correct configuration options should the administrator use to meet the item requirements?
(Choose three.)
For each procedure, indicate whether it is a correct or incorrect procedure that must be configured to meet the item requirements using the drop-down option.
正解:
解説:
Explanation
Ref:
質問 19
An administrator configure Active Directory (AD) authentication for their Nutanix environment. When login in using an AD user account, the login process takes more than one minute to complete. No delay occurs when logging a local account.
What should the administrator confirm to resolve this issue?
- A. The service Account Username is correct for the domain.
- B. The domain controller being used is configured as a global catalog server.
- C. The user search base for the group is configured correctly
- D. Active directory lookups are configured to use Non-Recursive mode.
正解: D
質問 20
An administrator is concerned that Prism will be inaccessible if Active Directory is unable to process logins.
Which method should the administrator use to access the cluster in the event of this type of outage?
- A. Manage the cluster by using the "nutanix" user on the Prism leader CVM
- B. Manage the cluster remotely by downloading ncli to a remote workstation
- C. Deploy an Active Directory server locally on the cluster
- D. Create and use an emergency local account on the cluster
正解: D
質問 21
A customer with a four-node RF2 cluster is adding application VMs to their system. After adding these VMs, the Prism dashboard shows 81% storage utilization.
What is the consequence of running the cluster at 81% storage utilization?
- A. There is available capacity in the storage fabric and the cluster is resilient.
- B. The customer has the ability to add more VMs up to the 100% storage utilization.
- C. The cluster is not resilient in the storage fabric
- D. Node failure is imminent due to storage utilization.
正解: C
解説:
Explanation
https://next.nutanix.com/how-it-works-22/recommended-maximum-storage-utilization-37234
質問 22
The networking team makes changes to the Top of Rack switches to which the Nutanix cluster are attached.
A few VMs are able to communicate with each other on the same node but are unable to connect to other parts of the network.
What is the likely cause of this issue?
- A. There is a VLAN misconfiguration on the VMs.
- B. The vNIC port is disconnected on the affected VMs.
- C. There is a VLAN misconfiguration on the switch.
- D. Jumbo Frame are misconfigured across ports.
正解: C
質問 23
Microsegmentation was recently enabled in a Nutanix environment. The administrator wants to leverage Prism Central to create a policy that will block all traffic, regardless of direction, between two groups of VMs identified by their category.
Which policy should be used to meet this requirement?
- A. A Whitehst-Based Policy
- B. An Application Security Policy
- C. An Isolation Environment Policy
- D. A Quarantine Policy
正解: C
解説:
質問 24
A customer with a four-node RF2 cluster is adding application VMs to their system. After adding these VMs, the Prism dashboard shows 81% storage utilization.
What is the consequence of running the cluster at 81% storage utilization?
- A. The cluster is not resilient in the storage fabric
- B. The customer has the ability to add more VMs up to the 100% storage utilization.
- C. There is available capacity in the storage fabric and the cluster is resilient.
- D. Node failure is imminent due to storage utilization.
正解: C
解説:
Explanation
https://next.nutanix.com/how-it-works-22/recommended-maximum-storage-utilization-37234
質問 25
An administrator needs to replace the self-signed certificate on a cluster. Which two requirements must be met as part of the process? (Choose two.)
- A. The imported files for the custom certificate must be PEM encoded.
- B. The signed, intermediate and root certificates are chained.
- C. The existing certificate must be deleted prior to replacement.
- D. The cluster administrator must restart the interface gateway.
正解: A,B
解説:
Explanation
Ref:
https://portal.nutanix.com/page/documents/details?targetId=Prism-Central-Guide-Prism-v55:mul-security-ssl-c
質問 26
An administrator is deploying an application that requires maximum I/O throughput for scratch data. The administrator is concerned that the throughput requirement is greater than what can be provided by a single cluster node.
What should the administrator do to meet this requirement?
- A. Create a virtual disk attached to the VM's PCI interface
- B. Create a volume group with several virtual disks and attach to the VM
- C. Create several virtual disks attached to the VM's virtual SCSI controller
- D. Create a volume group with one virtual disk attached to the VM
正解: B
解説:
Explanation
Ref:
https://next.nutanix.com/community-blog-40/scaling-up-vm-storage-performance-on-ahv-volume-group-load-b
質問 27
Refer to the exhibit.
User 1 and User 2 belong to the AAPM group
What are two descriptions of how Files perform quota management? (Choose two.)
- A. User 2 can continue to add another 3GB file but will receive a daily notification email.
- B. User 1 can continue to add another 5GB file but will receive a daily notification email.
- C. User 2 can add an 8GB file without receiving a notification email.
- D. User 1 can add an 8GB file to the share without receiving notification.
正解: B,C
解説:
Explanation
Ref:
https://portal.nutanix.com/page/documents/details?targetId=Files-v3_6:fil-file-server-quotas-c.html#nconcept_a
質問 28
Refer to the exhibit.
What is the purpose of eth2 on the CVMs?
- A. Network Segmentation
- B. iSCSI connectivity
- C. RDMA Network Segmentation
- D. Remote site connectivity
正解: A
解説:
Explanation
Ref: https://next.nutanix.com/installation-configuration-23/backplane-network-in-aos-5-5-27291
質問 29
An administrator has an existing Nutanix seven-node cluster running at RF2 that must be changed to have the following capabilities:
* RF3 set for the cluster
* Performance tier deduplication
What is the minimum memory needed on the CVMs to allow for these capabilities?
- A. 20G?
- B. 32GB
- C. 24GB
- D. 28GB
正解: D
解説:
Explanation
Ref:
https://next.nutanix.com/how-it-works-22/rf2-rf3-requirements-37206#:~:text=Controller%20VMs%20must%2
質問 30
A system administrator needs to shut down an AHV node in a Nutanix cluster without causing service disruption. The administrator checks data resiliency and verifies that the cluster can tolerate a node down.
Which three steps should the administrator perform next? (Choose three.)
正解:
解説:
Explanation
1 allow vms 2 sd CVM 3 sd node
質問 31
Refer to the exhibit.
After performing ESXi to AHV conversion on a cluster, the alerts shown in the exhibit display on Prism.
What should the administrator do to resolve this issue efficiently?
- A. Create a new Protection Domain and add the VMs to rt.
- B. Remove VMs from the Protection Domain and add them back in.
- C. Remove the VMs. create a new Protection Domain, and add VMs to it
- D. Delete the Protection Domain, create a new Protection Domain, and add the VMs to it
正解: B
質問 32
A guest VM is reported to have poor storage performance. It has an I/O profile of 80% read. 20% write, and the HDDs form more than 50% of the read source.
What should an administrator do to resolve this issue?
- A. Use HDDs with higher RPM
- B. Increase the OPLOG
- C. Increase the write cache
- D. Increase SSD capacity
正解: D
解説:
Explanation
Ref:
https://portal.nutanix.com/page/documents/solutions/details?targetId=BP-2126-SAS-on-Nutanix:BP-2126-SAS
質問 33
......
無料セールまもなく終了！100%有効なNCM-MCI-5.15試験：https://www.passtest.jp/Nutanix/NCM-MCI-5.15-shiken.html