[2023年11月18日] 手に入れよう!最新156-835認定された有効な試験問題集解答 [Q36-Q55]

Share

[2023年11月18日] 手に入れよう!最新156-835認定された有効な試験問題集解答

100%合格率保証付きの素晴らしい156-835試験問題PDF

質問 # 36
What is a downlink interface used for?

  • A. To connect Orchestrators to customer's infrastructure
  • B. To connect appliances to customer's infrastructure
  • C. To connect appliances to Orchestrators
  • D. To connect in between Orchestrators

正解:C


質問 # 37
Which command will be used in order to restart Orchestrator service only?

  • A. orchd restart
  • B. cpstop; cpstart
  • C. reboot
  • D. service orchestrator restart

正解:A

解説:
Page 313 from the training manual:
- Restart the service:
orchd restart
- Restart the service without confirmation
service orchd restart


質問 # 38
What is the default range of physical ports for downlinks on Orchestrator MHO-170?

  • A. 17 - 31
  • B. 25 - 32
  • C. 3 - 16
  • D. 1 - 16

正解:A


質問 # 39
There are two appliances within the same Security Group. One of them is connected by One downlink only, another one by Two downlinks. Assuming there's no NAT and no VPN, what would be proportion of traffic distribution done by Orchestrator?

  • A. 50%/50%
  • B. 100%/0%
  • C. 66%/33%
  • D. 33%/66%

正解:A


質問 # 40
What is the purpose of g_tcpdump command?

  • A. The same as tcpdump, just on Scalable Platform
  • B. Collects traffic dump from CIN network
  • C. Collects traffic dump from all Active Appliances within Security Group
  • D. Collects traffic dump from Sync network

正解:C


質問 # 41
Which setting is required in order to connect an appliance with 40Gbps downlink interface and DAC to the Orchestrator MHO-140?

  • A. On Appliance: Change a port speed to 10Gbps
  • B. No change required
  • C. On Orchestrator: Change QSFP mode from 100Gbps to 40Gbps
  • D. On Orchestrator: Change port type from uplink to downlink

正解:D


質問 # 42
When running ifconfig command on an Appliance, there are interfaces shown in the list: ethl-Sync and eth2-Sync. What is the purpose of these interfaces?

  • A. These interfaces represent physical Sync interface at the front panel of appliance
  • B. These interfaces can be used as backup for Sync interface
  • C. These interfaces are bond members (slaves) of Sync Bond
  • D. These interfaces are not in use. Security GW module use Sync interface for synchronization

正解:A


質問 # 43
Which is a valid requirement for a supported Maestro appliance?

  • A. 10GBps and 40Gbps or 100Gbps card with double-VLAN and LLDP support
  • B. At least one 10GBps line card
  • C. Line card with double-VLAN and LLDP support
  • D. Nothing special as Maestro supports any Check Point appliance

正解:A


質問 # 44
What is the throughput penalty of Security Group?

  • A. Depends on the type of Appliance
  • B. 10% per Security Group with no relation to amount of members
  • C. 5% per member
  • D. 1% per member

正解:A


質問 # 45
One single Appliance supports 1M concurrent connections. How many concurrent connections will support Security Group of 2 Appliances?

  • A. 500K
  • B. 1M
  • C. 4M
  • D. 2M

正解:D


質問 # 46
What cannot be a reason for "Failed to get remote orchestrator interfaces" error message, when clicking on "Orchestrator" in WebUI?

  • A. Remote orchestrator has no empty interfaces
  • B. One orchestrator only, but Orchestrator amount is 2 or no Sync in between orchestrators
  • C. Single orchestrator environment, but configured Orchestrator amount is 2
  • D. No Sync between orchestrators

正解:A


質問 # 47
What is the max amount of Orchestrators in Dual-site setup?

  • A. 0
  • B. 4 per Security Group
  • C. 1
  • D. 2 per Security Group

正解:A


質問 # 48
Which file on Appliance includes information about Security Group?

  • A. /etc/smodb.json
  • B. /etc/distutiljson
  • C. /etc/sgdb.json
  • D. /etc/chassisdb.json

正解:C


質問 # 49
What cannot be learned from the output of asg perf -v -p command?

  • A. Average CPU usage on Orchestrators
  • B. Real-time throughput
  • C. Average CPU usage on Appliances
  • D. Per-path distribution

正解:A


質問 # 50
What is the default Distribution mode?

  • A. Network
  • B. User
  • C. Auto-topology
  • D. Manual-General

正解:D


質問 # 51
What is the default IP range of Sync network (with no increment)?

  • A. The same as Management network
  • B. 192.0.2.0
  • C. 198.51.100.0
  • D. 192.168.1.0

正解:B


質問 # 52
There are two 10Gbps dual-port NIC installed on a 6800 appliance. Which interfaces should be connected to Orchestrator 1 for downlinks' intra-orchestrator redundancy when using two Orchestrators?

  • A. Port 1 in Slot 1 and Port 2 in Slot 1
  • B. Any pair of available ports
  • C. Port 1 in Slot 2 and Port 2 in Slot 1
  • D. Port 1 in Slot 1 and Port 1 in Slot 2

正解:A


質問 # 53
How many power supplies are presented on MHO-170?

  • A. 0
  • B. 1
  • C. 2
  • D. 1 with option for 2

正解:A


質問 # 54
What is the maximum amount of Appliances within Security group in Dual-Site configuration?

  • A. 0
  • B. 1
  • C. 2
  • D. 3

正解:A


質問 # 55
......

無料156-835別格な問題集をダウンロード:https://www.passtest.jp/CheckPoint/156-835-shiken.html

156-835問題集で2023年最新のCheckPoint試験問題:https://drive.google.com/open?id=1jm5mCYsaxEsePB6Duivr6owa109IaddR