ASQ CSSBB認定ガイドPDFは100%カバー率でリアル試験問題
合格させるCSSBB試験にはリアル問題解答
ASQ CSSBB 認定試験の出題範囲：
| トピック | 出題範囲 |
|---|---|
| トピック 1 |
|
| トピック 2 |
|
| トピック 3 |
|
| トピック 4 |
|
| トピック 5 |
|
| トピック 6 |
|
質問 17
The validity of the decision made with Hypothesis Testing is dependent upon all of the following except ______________________.
- A. Alpha risk
- B. Range of data
- C. Beta risk
- D. Sample size
正解: B
質問 18
When doing Hypothesis Testing on Non-normal data Belts will use a ________________ to compare more than two sample proportions to each other.
- A. Sakami Table
- B. Contingency Table
- C. Mean-to-Mode Analysis
- D. Z score Table
正解: C
質問 19
Find the value of (8) in the ANOVA table. Assume:
- A. 0.01<P<0.05
- B. 0.05<P<0.10
- C. 0.10<P<1
- D. 3.2
- E. 12.2
- F. 0<P<0.005
- G. 16.4
- H. 2.82
- I. 23.2
- J. 18.6
- K. 1.48
- L. 4.54
- M. 0.005<P<0.01
- N. 0.525
- O. 35.4
正解: F
質問 20
The median is a better choice than the mean for a measure of central tendency if the data:
- A. is normally distributed
- B. is bimodal
- C. often has outliers
- D. is exponentially distributed
正解: C
質問 21
Special Cause Variation falls into which two categories? (Note: There are 2 correct answers).
- A. Pattern
- B. Assignable
- C. Short term
- D. Natural
正解: A,B
解説:
Explanation
質問 22
To be an effective Lean Six Sigma practitioner one must understand the difference between
___________________________.
- A. Nonparametric tests and tests of Non-normal Data
- B. ANOVA and the Analysis of Variance
- C. F-test and test of variances of 2 samples
- D. Practical and Statistical significance
正解: D
解説:
Explanation
質問 23
Calculate the Rolled Throughput Yield of this process using this data.
DatA. unit input: 1450, unit output: 1390, defects repaireD. 320, scrap: 60
- A. 73.79%
- B. 71.33%
- C. 77.93%
- D. 72.66%
正解: D
質問 24
A(n) ________________ has occurred when two inputs have a greater impact on a change in the output than either of the inputs has by itself.
- A. Interaction
- B. Bimodal reaction
- C. Dependency
- D. Amplified effect
正解: A
解説:
Explanation
質問 25
One of the methods of testing a Measurement System is to have at least two people take multiple readings from the same instrument and of the same sample set to judge the Repeatability and Reproducibly. This approach is called a ______________ study.
- A. Dual Attribute
- B. Bimodal
- C. Correlation Analysis
- D. Gage R & R
正解: D
質問 26
Find the mean, median and mode of the following data set:
9, 11, 12, 12, 14, 18, 18, 18, 20, 23:
- A. 15.5, 16, 18
- B. 15.5, 18, 18
- C. 15, 12, 18
- D. 14, 16, 18
- E. 15, 14, 18
正解: A
質問 27
If the results from a Hypothesis Test are located in the "Region of Doubt" area, what can be concluded?
- A. We reject the Null Hypothesis
- B. The test was conducted improperly
- C. Rejection of the Alpha
- D. We fail to reject the Null Hypothesis
正解: A
質問 28
Which one of the listed tools is frequently used to help drill down to possible causes once a Fishbone Diagram is constructed?
- A. Ishikawa Diagram
- B. 5 Why Analysis
- C. 3 When Analysis
- D. Skeleton Diagnostic
正解: B
質問 29
A ____ from a sample is used to estimate a population _____. The two words that best fill these blanks are:
- A. parameter, value
- B. value, statistic
- C. item, value
- D. statistic, parameter
- E. parameter, statistic
正解: D
質問 30
What conclusion is most correct about the Experimental Design shown here with the response in the far right column?
- A. This design does not have enough experimental runs to conclude anything as evidenced by the lack of P-values in the MINITABTM output
- B. No factor has enough statistical confidence greater than 95% to have an impact on the response rate
- C. If the Adv is increased from the low level to the high level, the response rate increases
- D. The response level is statistically concluded to only need the Adv and Bev factors set at the low level to get the largest response rate
- E. Constant, Adv and Bev are the only factors statistically affecting the response rate with 95% confidence or more
正解: D
質問 31
At the very initiation of a project a Belt must develop a concise _______________ that states at a high level the area of concern and why it is important this issue be improved.
- A. Project Doctrine
- B. Management Justification
- C. Business Case
- D. Process Owner Disclosure
正解: B
質問 32
The relationship between a response variable and one or more independent variables is investigated and modeled by use of __________________.
- A. Critical X's Definition
- B. X-Y Matrix
- C. Analysis of Variance (ANOVA)
- D. Baldridge Assessment
正解: C
質問 33
In a series of linked processes and associated feedback loops the product or service flows ________ and the information flows ________.
- A. evenly, digitally
- B. none of the above
- C. sooner, later
- D. rapidly, slower
- E. to the customer, from the supplier
- F. downstream, upstream
正解: F
質問 34
A(n) ________________ has occurred when two inputs have a greater impact on a change in the output than either of the inputs has by itself.
- A. Interaction
- B. Bimodal reaction
- C. Dependency
- D. Amplified effect
正解: A
質問 35
The mean of a Poisson distribution is 2.94. Its standard deviation is:
- A. not enough information is given
- B. 1.31
- C. 1.71
- D. 8.64
- E. 74.7
正解: C
質問 36
When variation is removed from the output of a process then the process customer can have more confidence in the experience that results from the process.
- A. True
- B. False
正解: A
質問 37
The relationship between a response variable and one or more independent variables is investigated and modeled by use of __________________.
- A. Critical X's Definition
- B. X-Y Matrix
- C. Analysis of Variance (ANOVA)
- D. Baldridge Assessment
正解: C
質問 38
Which statement(s) are correct about the Pareto Chart shown here for the DOE analysis? (Note: There are 2 correct answers).
- A. The factors to keep in the mathematical model with a 5% alpha risk are BE, AB, A and AD
- B. The effects to keep in the mathematical model are E, D, DE, BD and B with an alpha risk equal to 0.05
- C. The factors to keep in the mathematical model are E, D, DE, BD and B with an alpha risk equal to 2.06
- D. It is unknown from this graph how many factors were in the Experimental Design
正解: B,D
質問 39
This QFD matrix was used in the design process for a ball point pen. What symbol is appropriate for the square labeled 7?
正解:
質問 40
Assessing process proportion as opposed to evaluating a process with respect to a set target can be done using one or more of these. (Note: There are 2 correct answers).
- A. Process proportion equals some desired value
- B. Proportion of the tail is equal
- C. Process proportion equals some value range
- D. Target is current
- E. When we deal with Attribute type data
正解: A,E
解説:
Explanation/Reference:
質問 41
......
100%無料CSSBB日常練習試験には300問があります：https://www.passtest.jp/ASQ/CSSBB-shiken.html
合格させるCSSBBレビューガイド、信頼され続けるCSSBBテストエンジン：https://drive.google.com/open?id=1U4s4kb_9mczTz8jtr6ydtftUEfu27Oro