PassTest NSE7_EFW-7.0問題集PDFで100%合格保証付き
NSE7_EFW-7.0ブレーン問題集でリアル試験最新問題2022年12月29日には122問題
質問 64
Examine the following partial output from a sniffer command; then answer the question below.
What is the meaning of the packets dropped counter at the end of the sniffer?
- A. Number of packets that matched the sniffer filter but could not be captured by the sniffer.
- B. Number of total packets dropped by the FortiGate.
- C. Number of packets that matched the sniffer filter and were dropped by the FortiGate.
- D. Number of packets that didn't match the sniffer filter.
正解: A
質問 65
Examine the following partial output from a sniffer command; then answer the question below.
What is the meaning of the packets dropped counter at the end of the sniffer?
- A. Number of packets that matched the sniffer filter but could not be captured by the sniffer.
- B. Number of total packets dropped by the FortiGate.
- C. Number of packets that matched the sniffer filter and were dropped by the FortiGate.
- D. Number of packets that didn't match the sniffer filter.
正解: A
質問 66
Refer to the exhibit, which contains the output of get system ha status.
Which two statements about the output are true? (Choose two.)
- A. The HA management IP is 169.254.0.2.
- B. Master is selected based on the priority configured under config system ha.
- C. The slave configuration is synchronized with the master.
- D. port7 is used as the HA heartbeat on all devices in the cluster.
正解: B,D
質問 67
Examine the IPsec configuration shown in the exhibit; then answer the question below.
An administrator wants to monitor the VPN by enabling the IKE real time debug using these commands:
diagnose vpn ike log-filter src-addr4 10.0.10.1
diagnose debug application ike -1
diagnose debug enable
The VPN is currently up, there is no traffic crossing the tunnel and DPD packets are being interchanged between both IPsec gateways. However, the IKE real time debug does NOT show any output .
Why isn't there any output?
- A. The IKE real time shows the phases 1 and 2 negotiations only. It does not show any more output once the tunnel is up.
- B. The log-filter setting is set incorrectly. The VPN's traffic does not match this filter.
- C. The IKE real time debug shows the phase 1 negotiation only. For information after that, the administrator must use the IPsec real time debug instead: diagnose debug application ipsec -1.
- D. The IKE real time debug shows error messages only. If it does not provide any output, it indicates that the tunnel is operating normally.
正解: B
質問 68
View the exhibit, which contains the output of a diagnose command, and then answer the question below.
Which statements are true regarding the output in the exhibit? (Choose two.)
- A. Servers with the D flag are considered to be down.
- B. Servers with a negative TZ value are experiencing a service outage.
- C. FortiGate will probe 121.111.236.179 every fifteen minutes for a response.
- D. FortiGate used 209.222.147.3 as the initial server to validate its contract.
正解: C,D
質問 69
A FortiGate device has the following LDAP configuration:
The administrator executed the 'dsquery' command in the Windows LDAp server 10.0.1.10, and got the following output:
>dsquery user -samid administrator
"CN=Administrator, CN=Users, DC=trainingAD, DC=training, DC=lab"
Based on the output, what FortiGate LDAP setting is configured incorrectly?
- A. password.
- B. dn.
- C. username.
- D. cnid.
正解: C
質問 70
Refer to the exhibit, which contains partial outputs from two routing debug commands.
Why is the port2 default route not in the second command's output?
- A. It has a higher distance than the default route using port1.
- B. It has a lower priority value than the default route using port1.
- C. It is disabled in the FortiGate configuration.
- D. It has a higher priority value than the default route using port1.
正解: A
質問 71
Examine the output of the 'diagnose sys session list expectation' command shown in the exhibit; than answer the question below.
Which statement is true regarding the session in the exhibit?
- A. It is for management traffic terminating at the FortiGate.
- B. It was created by the FortiGate kernel to allow push updates from FotiGuard.
- C. It is for traffic originated from the FortiGate.
- D. It was created by a session helper or ALG.
正解: D
質問 72
View the exhibit, which contains the output of a real-time debug, Which statement about this output is true?
Which of the following statements is true regarding this output?
- A. The requested URL belongs to category ID 255.
- B. The server hostname Is training, fortinet.com.
- C. This web request was inspected using the ftgd-allow web filler profile.
- D. FortiGate found the requested URL in its local cache.
正解: D
質問 73
Examine the output of the 'get router info bgp summary' command shown in the exhibit; then answer the question below.
Which statements are true regarding the output in the exhibit? (Choose two.)
- A. BGP peer 10.200.3.1 has never been down since the BGP counters were cleared.
- B. The local BGP peer has received a total of 3 BGP prefixes.
- C. BGP state of the peer 10.125.0.60 is Established.
- D. Local BGP peer has not received an Open Confirm from 10.200.3.1.
正解: C,D
質問 74
View the exhibit, which contains the partial output of an IKE real-time debug, and then answer the question below.
Why didn't the tunnel come up?
- A. The pre-shared keys do not match.
- B. The remote gateway is using aggressive mode and the local gateway is configured to use man mode.
- C. The remote gateway's phase 1 configuration does not match the local gateway's phase 1 configuration.
- D. The remote gateway's phase 2 configuration does not match the local gateway's phase 2 configuration.
正解: C
質問 75
Refer to the exhibit, which contains partial outputs from two routing debug commands.
Why is the port2 default route not in the second command's output?
- A. It has a higher distance than the default route using port1.
- B. It has a lower priority value than the default route using port1.
- C. It is disabled in the FortiGate configuration.
- D. It has a higher priority value than the default route using port1.
正解: A
質問 76
A FortiGate has two default routes:
All Internet traffic is currently using port1. The exhibit shows partial information for one sample session of Internet traffic from an internal user:
What would happen with the traffic matching the above session if the priority on the first default route (IDd1) were changed from 5 to 20?
- A. The session would remain in the session table, and its traffic would start to egress from port2.
- B. The session would remain in the session table, but its traffic would now egress from both port1 and port2.
- C. The session would be deleted, and the client would need to start a new session.
- D. The session would remain in the session table, and its traffic would still egress from port1.
正解: D
質問 77
Refer to the exhibit, which contains the output of diagnose sys session list.
If the HA ID for the primary unit is zero (0), which statement about the output is true?
- A. This session cannot be synced with the slave unit.
- B. The master unit is processing this traffic.
- C. This session is for HA heartbeat traffic.
- D. The inspection of this session has been offloaded to the slave unit.
正解: B
質問 78
What configuration changes can reduce the memory utilization in a FortiGate? (Choose two.)
- A. Reduce the maximum file size to inspect.
- B. Reduce the session time to live.
- C. Increase the FortiGuard cache time to live.
- D. Increase the TCP session timers.
正解: A,B
質問 79
View the exhibit, which contains the partial output of an IKE real time debug, and then answer the question below.
The administrator does not have access to the remote gateway.
Based on the debug output, what configuration changes can the administrator make to the local gateway to resolve the phase 1 negotiation error?
- A. Change phase 1 encryption to AES128 and authentication to SHA512.
- B. Change phase 1 encryption to AESCBC and authentication to SHA128.
- C. Change phase 1 encryption to 3DES and authentication to CBC.
- D. Change phase 1 encryption to 3DES and authentication to SHA256.
正解: C
質問 80
......
NSE7_EFW-7.0問題集には100%厳密検証された問題と解答で合格保証付きもしくは全額返金：https://www.passtest.jp/Fortinet/NSE7_EFW-7.0-shiken.html
最新NSE7_EFW-7.0PDF問題集リアル無料テスト本日更新です：https://drive.google.com/open?id=1QGsG4g4sFwfApa4j0heKFIpO77iUIX_0