• ホーム
  • ブログ
  • [2023年11月27日] 心強いNS0-184のPDF問題集はNS0-184問題 [Q20-Q44]

[2023年11月27日] 心強いNS0-184のPDF問題集はNS0-184問題 [Q20-Q44]

Share

[2023年11月27日] 心強いNS0-184のPDF問題集はNS0-184問題

正真正銘のNS0-184問題集で無料PDF問題で合格させる

質問 # 20
What are two ways to identify an AFF All SAN Array system? (Choose two.)

  • A. Use the cluster image show CLI command.
  • B. View the ONTAP System Manager cluster settings.
  • C. Use the san config show CLI command.
  • D. View the ONTAP System Manager system nodes.

正解：C、D


質問 # 21
You are installing a new AFF A400 cluster and need to access the cluster management LIF from a remote subnet with the fully qualified domain name (FQDN) a400.lab.netapp.com.
In this scenario, which two network components must be configured to log in to ONTAP System Manager from the remote subnet? (Choose two.)

  • A. VLAN
  • B. route
  • C. NTP
  • D. DNS

正解：B、D


質問 # 22
Your customer is migrating data from a legacy FAS8020 system that runs ONTAP 9.5 software to a new AFF A250 MetroCluster over IP configuration.
In this scenario, which two methods would be supported to migrate the data? (Choose two.)

  • A. Configure a SnapMirror copy between the FAS8020 and the AFF A250 systems.
  • B. Use a host-based copy migration method.
  • C. Create a 4-node cluster on one side and use the vol move command to migrate the data.
  • D. Perform a controller swap from the FAS8020 to the AFF A250s.

正解：A、D


質問 # 23
An ONTAP cluster is installed at a secure site. The array has no access to the Internet but is managed 24/7 by onsite engineers. The customer requires that when hardware failures occur, the failures are reported to the NetApp Support team as quickly as possible.
In this scenario, which two tasks should be performed during the project hand-off procedure to satisfy the customer's requirement? (Choose two.)

  • A. Educate the onsite engineers about invoking the AutoSupport tool from ONTAP System Manager.
  • B. Ensure that Active IQ Config Advisor is installed.
  • C. Ensure that the onsite engineers receive EMS alerts when hardware issues occur.
  • D. Educate the onsite engineer about how to manually log support calls.

正解：A、C


質問 # 24
You are installing a new AFF A400 cluster that is running ONTAP 9.7 software. You are asked to attach an Amazon S3 cloud tier for FabricPool technology.
In this scenario, which two NetApp License File (NLF) types are supported for cloud tiering? (Choose two.)

  • A. term-based
  • B. base
  • C. master
  • D. perpetual

正解：A、D


質問 # 25
You have installed and configured a new AFF C190 cluster with ONTAP 9.7. Your customer wants you to install the latest version of ONTAP.
In this scenario, what are two methods to update ONTAP? (Choose two.)

  • A. Use the cluster image package get and cluster image update commands.
  • B. Use ONTAP System Manager to download and install the new software image.
  • C. Use a USB drive with the new software image and let ONTAP automatically boot.
  • D. Use ONTAP System Manager to upload and install the new software image.

正解：A、B


質問 # 26
Your customer wants to know more about the network configuration within the cluster.
In this scenario, which statement is correct about a LIF?

  • A. A LIF is created within a broadcast domain and contains a pool of IP address.
  • B. A LIF is a port that provides physical connections.
  • C. A LIF is an IP address or a WWPN that is associated with a port.
  • D. A LIF separates network domains to access cluster data.

正解：C


質問 # 27
Click the Exhibit button.

You are setting up a new AFF A700 into a new rack at a customer's site. The customer asks you to plan for simplified future growth.
Referring to the exhibit, how would you satisfy this requirement?

  • A. Option 2
  • B. Option 3
  • C. Option 1
  • D. Option 4

正解：A


質問 # 28
When creating a new 3.8 TB SSD-based aggregate, what is the default RAID type used with ONTAP 9.8?

  • A. RAID 4
  • B. RAID DP
  • C. RAID 0
  • D. RAID-TEC

正解：B


質問 # 29
While installing a new AFF A400 HA pair, you are unable to add an NTP server from another subnet. You are able to ping the NTP server from the new cluster.
In this scenario, what are two causes of this problem? (Choose two.)

  • A. A firewall is blocking port 123.
  • B. The time skew is too great.
  • C. The cluster management LIF needs to be in a different IPspace.
  • D. The admin SVM has the wrong gateway.

正解：C、D


質問 # 30
You are preparing to physically install a new AFF A400 cluster into a customer's racks. All equipment has been delivered to the customer's site.
Which three tools do you need to complete this installation? (Choose three.)

  • A. laptop computer
  • B. additional network cables
  • C. slide rail kit
  • D. Phillips #2 screwdriver
  • E. cable management tray

正解：A、B、D


質問 # 31
Which two SVMs are automatically created during the cluster setup? (Choose two.)

  • A. node SVM
  • B. data SVM
  • C. admin SVM
  • D. system SVM

正解：C、D


質問 # 32
You have an AFF All SAN Array (ASA) cluster that is running ONTAP 9.7. The cluster is configured for Active Directory domain controller access using a domain tunnel.
In this scenario, which two licenses are enabled on the cluster? (Choose two.)

  • A. NVMe
  • B. FCP
  • C. iSCSI
  • D. CIFS

正解：B、D


質問 # 33
You are preparing to install a new 2-node AFF A250 system at a customer site with an existing cluster that uses NetApp CN1610 cluster interconnect switches.
In this scenario, what are two valid actions for this installation? (Choose two.)

  • A. Create a new 2-node switched cluster that uses the CN1610 cluster switches.
  • B. Migrate the existing cluster to new switches and add the new nodes.
  • C. Add the new nodes to the existing cluster and switches.
  • D. Create a new 2-node switchless cluster.

正解：A、B

解説：
Reference:
https://kb.netapp.com/Advice_and_Troubleshooting/Flash_Storage/AFF_Series/Controller_Hardware_Upgrade3A_Adding_AFF_A250_nodes_to_existing_cluster_report_HA_interconnect_errors_and_c
annot_perform_takeover


質問 # 34
A customer is asked to install a new AFF ASA A700 system. During the installation, the customer asks if ONTAP 9.8 is supported with their host's OS version running Windows 2016.
In this scenario, which NetApp tool would verify supportability?

  • A. Active IQ OneCollect
  • B. ONTAP System Manager
  • C. Active IQ Unified Manager
  • D. Interoperability Matrix Tool

正解：B


質問 # 35
Click the Exhibit button.

Referring to the numbers shown in the exhibit, which port on an AFF A220 controller is used as port e0M in ONTAP?

  • A. 0
  • B. 1
  • C. 2
  • D. 3

正解：D


質問 # 36
After moving a new AFF A400 cluster into production, the administrator notices error events in ONTAP System Manager regarding SAS HA issues.
In this scenario, which NetApp tool would have identified these errors after the installation process?

  • A. ONTAP System Manager
  • B. Cloud Manager
  • C. Active IQ Unified Manager
  • D. Active IQ Config Advisor

正解：A


質問 # 37
A customer requires encryption at rest on every node root volume.
In this scenario, which two encryption solutions will fulfill this requirement? (Choose two.)

  • A. NSE
  • B. NVE
  • C. IPsec
  • D. NAE

正解：B、D


質問 # 38
You installed a new 4-node AFF A400 ONTAP 9.8 cluster. The AFF400 controller data ports were automatically discovered by "automatic port placement".
In this scenario, which two ONTAP network settings were automatically configured? (Choose two.)

  • A. broadcast domains
  • B. routes
  • C. subnets
  • D. IPspaces

正解：B、C


質問 # 39
After completing the installation of an AFF A800 ONTAP AI cluster, you are asked which contacts are available for additional help in obtaining immediate assistance in solving P1 issues.
In this scenario, what do you tell the customer?

  • A. Contact NetApp Support by telephone.
  • B. Use Guided Problem Solving.
  • C. Use the NetApp KB TV channel.
  • D. Contact NetApp Support using chat.

正解：A


質問 # 40
You are asked to add a new HA pair to an existing 2-node switchless AFF A220 cluster. You must first convert to a 2-node switched cluster using Broadcom BES-53248 cluster switches.
Which two conditions must be fulfilled before you start the migration? (Choose two.)

  • A. The 2-node switchless configuration must be properly set up and functioning.
  • B. All cluster LIFs must be in the up state and on their home ports.
  • C. The "Enabled Switchless Cluster" option must be manually set to "false".
  • D. All cluster LIFs must have an MTU size of 1500.

正解：A、B


質問 # 41
Click the Exhibit button.

Referring to the exhibit, you installed a new AFF A250 HA system with FC at a customer site. The customer asks how many ports can be used for the Ethernet host connections.
In this scenario, what would you tell the customer?

  • A. 0
  • B. 1
  • C. 2
  • D. 3

正解：C


質問 # 42
Before installing an 8-node cluster for a customer, you want to validate compatibility with existing hardware.
Which two tools would you use to validate the configuration? (Choose two.)

  • A. Active IQ System Manager
  • B. Hardware Universe
  • C. Active IQ Config Advisor
  • D. Interoperability Matrix Tool

正解：C、D


質問 # 43
You have just finished installing and configuring an ONTAP cluster for a customer.
In this scenario, which product collects information and produces site documentation?

  • A. Active IQ OneCollect
  • B. NetAppDocs
  • C. Inventory Collect Tool
  • D. SnapGathers

正解：B


質問 # 44
......

結果を保証するには最新2023年11月無料：https://www.passtest.jp/NetworkAppliance/NS0-184-shiken.html

有効な問題最新版を無料で試そうNS0-184試験問題集解答：https://drive.google.com/open?id=1TdIL4L5EdPiBDReFC6OHiHP6VnpHebm3

関するブログ

もっと
NS0-184 無料問題集