2024年10月 Network Appliance NS0-184実際の問題とブレーン問題集
NS0-184合格させる問題集でNetwork Appliance24時間で試験合格できます
NS0-184認定試験を受験するための資格要件は、NetAppストレージシステムがONTAPで実行される環境で6〜12ヶ月以上の経験があることが必要です。また、ファイバーチャネルおよびiSCSIプロトコルなどのストレージネットワーキングに関する堅実な理解を持ち、基本的なLinuxコマンドにも精通している必要があります。
Network Appliance NS0-184試験は、NetApp Certified Storage Installation Engineer、ONTAP Examとしても知られており、NetApp ONTAPストレージシステムをインストール、設定、管理するために必要なスキルと知識をテストするために設計されています。この試験は、ITで働き、NetAppストレージシステムの経験を持つ個人を対象としています。試験は、NetApp Certified Storage Installation Engineerになるための必須要件です。
Network Appliance NS0-184は、NetAppストレージのインストールに特化したプロフェッショナルのスキルと知識を評価する試験です。この試験は、さまざまな環境でのNetAppストレージソリューションの実装に関する専門知識をテストします。この試験に合格することは、NetAppストレージのインストールにおけるスキルを証明したいITプロフェッショナルにとって、重要な達成です。
質問 # 26
You have a 2-node FAS8300 ONTAP 9.8 cluster that serves SMB shares. You are configuring interface groups for higher performance and resiliency.
Which two NetApp best practices should you follow to satisfy these performance and resiliency requirements? (Choose two.)
- A. Use ports with different chipsets.
- B. Use ports from different NICs.
- C. Use ports from the same NICs.
- D. Use ports with the same chipsets.
正解：B、D
質問 # 27
After the installation of a new ONTAP 9.8 cluster, you have to verify if AutoSupport works.
In this scenario, which two commands would you use to accomplish this task? (Choose two.)
- A. system node autosupport destination show
- B. system node autosupport invoke
- C. system node autosupport check show
- D. system node autosupport history show
正解：C、D
質問 # 28
You are expanding an existing 4-node ONTAP 9.8 cluster with a FAS8300 HA pair by adding a new FAS500f HA pair. Before the expansion, you are asked to save the configuration of the cluster to a backup file.
In this scenario, which two ONTAP configuration backup methods are available? (Choose two.)
- A. cluster
- B. storage VM
- C. switch
- D. node
正解：A、B
質問 # 29
You want to add an AFF A400 HA pair to an existing cluster.
In this scenario, which LIF type is required?
- A. cluster-mgmt
- B. data
- C. intercluster
- D. node-mgmt
正解：C
質問 # 30
You installed a new 2-node FAS500f ONTAP 9.8 switchless cluster that serves NAS volumes to both NFSv4.1 and SMB clients. The host operating systems have full flow control enabled on their data ports.
In this scenario, which two flow control settings would you verify? (Choose two.)
- A. Verify that the data network ports have full flow control disabled.
- B. Verify that the data network ports have full flow control enabled.
- C. Verify that the cluster network ports have full flow control disabled.
- D. Verify that the cluster network ports have full flow control enabled.
正解：A、D
質問 # 31
Click the Exhibit button.
Referring to the exhibit, you installed a new AFF A250 HA system with FC at a customer site. The customer asks how many ports can be used for the Ethernet host connections.
In this scenario, what would you tell the customer?
- A. 0
- B. 1
- C. 2
- D. 3
正解：B
質問 # 32
Click the Exhibit button.
You want to add a FAS2750 HA pair to an existing 6-node cluster.
Referring to the exhibit, which action would you perform to begin adding the node?
- A. Use the node setup wizard and select 0a as the management interface.
- B. Use the exit or quit commands then run the cluster setup command.
- C. Use the back command to begin the Cluster Setup wizard.
- D. Reboot the node and enter maintenance mode and run the Cluster Setup wizard.
正解：A
質問 # 33
In an ONTAP switched cluster, which three types of traffic travels over the cluster network? (Choose three.)
- A. Epsilon voting
- B. intercluster SnapMirror
- C. intracluster SnapMirror
- D. cluster database replication
- E. remote cluster peering
正解：B、D、E
質問 # 34
Click the Exhibit button.
A customer wants to replace their ONTAP cluster CN1610 switches with Cisco Nexus 3132Q-V switches. They want to perform a non-disruptive upgrade.
Referring to the exhibit, which cable will be required to non-disruptively migrate to the new switches?
- A. a 40GbE QSFP+ to QSFP+ cable
- B. a 40GbE QSFP+ to 4x10GbE SFP+ cable
- C. a 10GbE SFP+ to SFP+ cable
- D. a 100GbE QSFP28+ to 4x25GbE SFP28+ cable
正解：D
質問 # 35
Your customer wants a newly installed AFF C190 cluster to send SNMP notifications to a trap host called OVERWATCH01.
In this scenario, which two statements are correct? (Choose two.)
- A. Configure a trap host on the cluster.
- B. Configure DNS on the cluster.
- C. Configure an SNMP community string on the cluster.
- D. Configure a firewall policy and allow SNMP.
正解：A、B
質問 # 36
You are installing a new ONTAP 9.7 cluster by following the installation and setup poster. You are ready to complete the initial cluster setup. You have connected your laptop to the management switch. However, when browsing the network, you are unable to discover the ONTAP controllers.
Which statement explains this behavior?
- A. You do not have a static IP address.
- B. You do not have network discovery enabled.
- C. You do not have IPv6 configuration set.
- D. You do not have a default gateway set.
正解：D
質問 # 37
You have an AFF All SAN Array (ASA) cluster that is running ONTAP 9.7. The cluster is configured for Active Directory domain controller access using a domain tunnel.
In this scenario, which two licenses are enabled on the cluster? (Choose two.)
- A. iSCSI
- B. NVMe
- C. CIFS
- D. FCP
正解：C、D
質問 # 38
Which two statements are true about the LIFs that are used for a cluster peer relationship? (Choose two.)
- A. At least one LIF per node is required on each cluster.
- B. The LIFs must use the default intercluster service policy.
- C. The LIFs must be in dedicated broadcast domains an IPspaces.
- D. The MTU size must be set to 9000 bytes on all the LIFs used for the cluster peering.
正解：B、C
質問 # 39
You are installing a new ONTAP 9.7 cluster and attaching the cluster to two separate networks. Your customer has indicated that the same range of client IP addresses are used on both networks and that the networks are never allowed to communicate with each other.
In this scenario, which ONTAP feature must be configured to securely allow all clients to access ONTAP NAS protocols?
- A. IPspaces
- B. routing
- C. BGP
- D. broadcast domains
正解：D
質問 # 40
You install a 4-node cluster with an AFF A400 HA pair and a FAS8300 HA pair. After setup, you are asked to review the audit logs on each controller from a Web browser.
In this scenario, which method provides access to the logs from a Web browser?
- A. ACP
- B. SPI
- C. DNS
- D. ADP
正解：B
質問 # 41
A storage administrator is trying to upgrade a pair of FAS2520s with internal SATA storage to a new 2-node FAS8300 cluster. The storage administrator wants to preserve the existing data.
In this scenario, which two capabilities are available to the storage administrator? (Choose two.)
- A. the ability to convert the FAS2520s to disk shelves and attach them to the new nodes
- B. the ability to move the volumes from the old nodes to the new nodes
- C. the ability to pull out the tray of internal disks of the FAS2520s and reseat the tray in the internal storage of the FAS8300s
- D. the ability to create a 4-node MetroCluster across the four nodes
正解：A、D
質問 # 42
Click the Exhibit button.
You are installing a new AFF All SAN Array A700 HA pair.
Referring to the exhibit, which IP address would have been used to join node 02 to the cluster during setup?
- A. 169.254.212.198
- B. 192.168.0.101
- C. 169.254.145.151
- D. 192.168.0.112
正解：D
質問 # 43
Which command would be used to measure the throughput and latency of traffic between nodes?
- A. network test-path
- B. statistics node show
- C. qos statistics workload performance show
- D. cluster ping-cluster
正解：A
質問 # 44
You have completed a base installation and system registration of an AFF A250 system, but you notice that you have one failed drive. Neither "un-failing" nor reseating the drive helped to repair it. You must ensure proper replacement of the failed drive.
In this scenario, which two actions should you take? (Choose two.)
- A. Run Active IQ Config Advisor to collect all the logs on the system.
- B. Ask the customer to open a technical case with NetApp Support.
- C. Power off the system until the drive has been replaced.
- D. Ask the customer for a drive with the same capacity and replace it.
正解：A、D
質問 # 45
You have an AFF A400 cluster that is running ONTAP 9.7 software. You are asked to set up FlexCache for NFS volumes.
In this scenario, which statement is correct when implementing FlexCache?
- A. A site license is required.
- B. A capacity license is required.
- C. No license is required.
- D. A subscription license is required.
正解：B
質問 # 46
You are expanding an existing cluster that uses BES-53248 cluster interconnect switches. You connected the new controllers to ports 0/17 through 0/20. However, you are unable to join the new nodes to the cluster.
Which action must be taken to solve the problem?
- A. Install the reference configuration file.
- B. Reboot the controllers.
- C. Install the license file.
- D. Install the CSHM configuration file.
正解：A
質問 # 47
Click the Exhibit button.
You are attempting to add a new ONTAP 9.7 node to your ONTAP 9.8 NetApp cluster. After attempting to add the node, it fails as shown in the exhibit.
What are two nondisruptive ways to add the new node to your ONTAP cluster? (Choose two.)
- A. Add the node using the -allow-mixed-version- parameter.
- B. Revert the cluster from ONTAP 9.8 to ONTAP 9.7.
- C. Re-initialize all the nodes in the ONTAP cluster with ONTAP 9.7.
- D. Upgrade the new node from ONTAP 9.7 to ONTAP 9.8.
正解：A、D
質問 # 48
......
最新問題をダウンロードNS0-184問題集で2024年最新のNS0-184試験問題集：https://www.passtest.jp/NetworkAppliance/NS0-184-shiken.html
最新問題を使おうNS0-184試験問題と解答PDFで一年間無料更新：https://drive.google.com/open?id=1Of8CVsqcqUxUimP4l8tXcliBCA0jNyE5