NACE NACE-CIP2-001練習テストPDF試験材料
NACE-CIP2-001解答NACE-CIP2-001無料サンプルには全てリアル試験合格させます
質問 # 24
When performing an adhesion test in accordance with ASTM D 3359 where the Dry Film Thickness is approximately 10 mils, the Inspector should use:
- A. Method B - X cut
- B. Method A - Cross Hatch
- C. Method B - Cross Hatch
- D. Method A - X Cut
正解：D
質問 # 25
From a corrosion perspective, the main difference between Ferrous and Non-Ferrous Metals is:
- A. Iron content
- B. Cost
- C. Appearance
- D. Safety
正解：A
質問 # 26
NACE Level 2 Inspectors have been authorized to perform:
- A. Visual inspection, Non-Destructive and Destructive testing
- B. All types of inspection without supervision
- C. Visual inspection and Non-destructive testing
- D. Visual inspection only
正解：A
質問 # 27
Antifouling coatings are regulated by international treaties.
- A. False
- B. True
正解：B
質問 # 28
Which surface preparation method uses a dilute acid solution to remove laitance and I roughen the concrete surface?
- A. Stoning
- B. Acid etching
- C. Sacking
- D. High-pressure water washing
正解：B
質問 # 29
You are the NACE Level 2 Inspector with the final responsibility to prepare the final report for a very large structural steel shop project which has gone very well. It is due next week. The work has been ongoing for two years and several NACE Level 1 Inspectors have worked under your supervision throughout the project. You find you are missing one week of daily reports for the night shift from the very beginning of the project and despite your best efforts they are cannot found.
You FIRST preferred course of action is to:
- A. Plainly state in your report that they are missing
- B. Use creative writing to cover over the fact they are missing
- C. Do not complete your report until they can be found
- D. Re-create the reports as not much was going on during night shift anyway
正解：A
質問 # 30
Eddy current DFT gauges are used to measure Dry Film Thickness in which of the following situations:
- A. Conductive coatings applied to a cementitious substrate
- B. Magnetic coatings applied to a magnetic metallic substrate
- C. Conductive coatings applied to a magnetic metallic substrate
- D. Non-Conductive coatings applied to a conductive metallic substrate
正解：D
質問 # 31
Inspectors perform tests on linings that they may not perform on exterior coatings because
- A. coatings are more durable than linings.
- B. coatings are expected to degrade over time.
- C. linings protect the contents and the container.
- D. linings are more durable than coatings.
正解：C
質問 # 32
When performing a hardness test on a coating which has elastic properties the inspector is likely to likely to observe:
- A. A very high reading
- B. No difference from any other coating
- C. A very low reading
- D. Cold flow or creep
正解：D
質問 # 33
Pre-cleaning of work pieces will NOT remove
- A. mill scale.
- B. snow, ice or water.
- C. oil or grease.
- D. dirt.
正解：A
質問 # 34
You are working as the only in-house NACE Level 2 Inspector in a shop setting when an independent 3 rd party NACE Level 3 Inspector, representing the owner, presents you with a copy of a Non Conformance Report (NCR) he has written for a NACE2/SSPC SP 10 centrifugal blast which you had previously approved.
Your FIRST preferred course of action is to:
- A. Consult your supervisor
- B. Verbally challenge the NCR
- C. Review the NCR with the other Inspector
- D. Request a re-blast of the item in question
正解：A
質問 # 35
All of these are advantages of using repair patches EXCEPT
- A. barrier to moisture and corrosion.
- B. inert to common acids, alkalis, and solvents.
- C. excellent abrasion resistance.
- D. special tools or equipment are required.
正解：D
質問 # 36
As a NACE Level 2 Inspector on a field job; prior to submission your documentation should always reviewed and approved by:
- A. A NACE Level 1 Inspector
- B. A NACE Level 3 Inspector
- C. A NACE Protective Coating Specialist
- D. Another NACE Level 2 Inspector
正解：B
質問 # 37
On pipelines, which coating is identifiable by its distinct colors, usually light blue, green, or grey?
- A. Coal Tar Enamel
- B. Liquid epoxies
- C. Heat-shrink sleeves
- D. Concrete
正解：B
質問 # 38
Cold-applied tape
- A. is typically green or led and looks like "painted" finish.
- B. have a cross-linked polyethylene backing and a heat-activated adhesive.
- C. is polyethylene film, heat laminated, 'With an adhesive layer of butyl glue.
- D. are identifiable by its distinct colors, usually light blue, green, Or Grey.
正解：C
質問 # 39
When ASIN D 3363 is specified the Inspector must:
- A. Record the two end points identified in the standard
- B. Record the highest value attained
- C. Record the percentage of failure
- D. Use the correct solvent
正解：A
質問 # 40
Coating surveys may include which steps?
Select All That Apply:
- A. Summarize the collected data
- B. Evaluate the coatings performance
- C. Schedule the remedial work
- D. Develop a survey plan
正解：A、B、C、D
質問 # 41
When environmental enclosures are being used an inspector needs to be concerned about:
- A. Lighting
- B. a), b), and c)
- C. Structural integrity
- D. Air changes
正解：B
質問 # 42
Thermal Spray coatings provide:
- A. Barrier protection
- B. Sacrificial protection
- C. Thermal protection
- D. Inhibitive protection
正解：B
質問 # 43
......
NACE-CIP2-001[2025年12月] 最新リリース] 試験問題あなたを必ず合格させます：https://www.passtest.jp/NACE/NACE-CIP2-001-shiken.html
NACE NACE-CIP2-001試験の基礎問題と解答：https://drive.google.com/open?id=19bQkE75lVm39lFuh75cpmfZlV0s4s1Kz